Category Archives: CCNA

2.0 Voucher Cevaplari

Posted on 18 Nisan 2011 by Belgeci

Bu sinav digerlerine gore biraz daha serttir 60 soru bulunmaktadir. Bu sinavdan yanlis hatirlamiyorsam 80 ve ustu alirsaniz CCNA INTRO sinavi icin size %50 indirim kuponu veriyorlar. Ki bu cevaplarla 90 ustu almaniz isten bile degil ancak sorular farkli cikabilir … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-1 | Leave a comment

3.0 Final Cevaplari

Posted on 18 Nisan 2011 by Belgeci

Bu sinava bizzat girdim %93 aldim 2 bos biraktim ve 1 yanlis… Umarim sizelere de yardimci olur bu cevaplar1 Refer to the exhibit. What will be the result of DR elections in the OSPF network shown? (Choose three.) *** R1 will … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.1 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1Which of the following is considered a limitation of RIP v1? *** RIP v1 does not send subnet mask information in its updates. RIP v1 is not widely supported by networking hardware vendors. RIP v1 consumes excessive bandwidth by multicasting routing updates using … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.2 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1What does OSPF use to calculate the cost to a destination network? *** bandwidth bandwidth and hop count bandwidth and reliability bandwidth, load, and reliablity    2A network administrator has configured a default route on Router_A but it is not being shared with adjacent Router_B … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.3 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1Why would it be necessary to configure the bandwidth setting on an EIGRP interface rather than leaving it at the default setting? (Choose two.) *** A suboptimal route may be chosen as the best path to a destination if the bandwidth … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.4 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1Which attribute is used by a bridge to make forwarding decisions? source IP address source MAC address destination IP address *** destination MAC address Layer 4-7 protocol address    2What is the effect of adding additional hosts to a half-duplex Ethernet network? (Choose three.) *** collisions increase collisions … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.5 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

Which of the following are requirements of LAN design? (Choose three.) *** adaptability *** manageability operability *** scalability stabilityWhen designing a LAN, at which layer of the OSI model does the process of segmenting collision domains occur? Layer 1 *** Layer 2 Layer 4 Layer 7Which of the following … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.6 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1What is the default setting for the mode LED on a switch? *** STAT FDUP UTIL 100 PORT    2An old workstation has been replaced with a new one. The workgroup switch is not learning the MAC address of the new workstation. A network technician has … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.7 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1 Refer to the graphic. Server sends an ARP request for the MAC address of its default gateway. If STP is not enabled, what will be the result of this ARP request? Router_1 will kill the broadcast and reply with the MAC … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.8 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1Which of the following states the 80/20 rule of end-to-end VLANs? 80% of network resources should be remote and 20% should be on the local VLAN. 80% of VLANs should be static and the remaining 20% should be dynamic. *** 80% of network … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

3.9 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1What information does frame tagging add to each frame to allow delivery of frames across a switched trunk? the destination MAC address the switch MAC address *** the VLAN ID the BID    2 Switch1 is not participating in the VTP management process with the other … Continue reading →

Posted in Modul Sinav Sorulari Cevaplari | Leave a comment

4.0 Final Cevaplari

Posted on 18 Nisan 2011 by Belgeci

    1Which of the following describes the roles of devices in a WAN? (Choose three.) *** A CSU/DSU terminates a digital local loop. A modem terminates a digital local loop. A CSU/DSU terminates an analog local loop. *** A modem terminates an analog local … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment

4.0 Practice Final Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1A network administrator is asked to design a system to allow simultaneous access to the Internet for 250 users. The ISP for this network can only supply five public IPs. What can be used to accomplish this task? routable translation dynamic translation static … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment

4.0 Voucher Cevaplari

Posted on 18 Nisan 2011 by Belgeci

Not : Bu cevaplari aynen gecirirseniz alacaginiz puan %80  dir.What is accomplished by segmenting a LAN with a bridge? *increase large collision domains reduce large collision domains reduce small broadcast domains increase small broadcast domains 2 How many Telnet sessions … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment

4.1 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1What is the default number of pings issued by a DHCP server to a pool address before sending the DHCPOFFER to a client? one *** two three four five    2 Refer to the graphic. Which command would allow the router to forward DHCP broadcasts from Host … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment

4.2 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

     1Which statements are correct regarding ATM connections? (Choose two.) uses only PVCs *** is useful for video transfers *** has data rates beyond 155 Mbps cells have 32 byte payload and a 5 byte overhead mandates single virtual circuits on a single leased line … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment

4.3 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

How did Cisco alter the HDLC encapsulation to allow a single link to carry multiple protocols? split the transmissions into multiple channels each carrying a single protocol identified the protocol in the FCS field compressed the datagrams differently for each protocol *** added a … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment

4.4 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

1Why must routers be configured to specify the ISDN switch type? *** Switches use various implementations of Q.931. The IOS of most routers lacks the ability to autosense the switch. The switch must know what type of router it is communicating with. The Layer … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment

4.5 Quiz Cevaplari

Posted on 18 Nisan 2011 by Belgeci

Which data link layer protocol is used to carry frames across a Frame Relay link? HDLC PPP LAPD *** LAPF Frame RelayWhich of the following statements are true about a basic Frame Relay WAN connection between a customer and the service provider? (Choose two.) *** DTE … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment

4.6 Quiz cevaplari

Posted on 18 Nisan 2011 by Belgeci

1Which statements are true regarding configuring SNMP? (Choose three.) It is best to use the default read-only community strings in enterprise networks. *** It is not advisable to use the default read-write community string in an enterprise network. *** More than one read-only … Continue reading →

Posted in Modul Sinavlari ve Cevaplari-2 | Leave a comment