Category Archives: Modul Sinav Sorulari Cevaplari

Bu sinava bizzat girdim %93 aldim 2 bos biraktim ve 1 yanlis… Umarim sizelere de yardimci olur bu cevaplar1 Refer to the exhibit. What will be the result of DR elections in the OSPF network shown? (Choose three.) *** R1 will … Continue reading →

1Which of the following is considered a limitation of RIP v1? *** RIP v1 does not send subnet mask information in its updates. RIP v1 is not widely supported by networking hardware vendors. RIP v1 consumes excessive bandwidth by multicasting routing updates using … Continue reading →

1What does OSPF use to calculate the cost to a destination network? *** bandwidth bandwidth and hop count bandwidth and reliability bandwidth, load, and reliablity    2A network administrator has configured a default route on Router_A but it is not being shared with adjacent Router_B … Continue reading →

1Why would it be necessary to configure the bandwidth setting on an EIGRP interface rather than leaving it at the default setting? (Choose two.) *** A suboptimal route may be chosen as the best path to a destination if the bandwidth … Continue reading →

1Which attribute is used by a bridge to make forwarding decisions? source IP address source MAC address destination IP address *** destination MAC address Layer 4-7 protocol address    2What is the effect of adding additional hosts to a half-duplex Ethernet network? (Choose three.) *** collisions increase collisions … Continue reading →

Which of the following are requirements of LAN design? (Choose three.) *** adaptability *** manageability operability *** scalability stabilityWhen designing a LAN, at which layer of the OSI model does the process of segmenting collision domains occur? Layer 1 *** Layer 2 Layer 4 Layer 7Which of the following … Continue reading →

1What is the default setting for the mode LED on a switch? *** STAT FDUP UTIL 100 PORT    2An old workstation has been replaced with a new one. The workgroup switch is not learning the MAC address of the new workstation. A network technician has … Continue reading →

1 Refer to the graphic. Server sends an ARP request for the MAC address of its default gateway. If STP is not enabled, what will be the result of this ARP request? Router_1 will kill the broadcast and reply with the MAC … Continue reading →

1Which of the following states the 80/20 rule of end-to-end VLANs? 80% of network resources should be remote and 20% should be on the local VLAN. 80% of VLANs should be static and the remaining 20% should be dynamic. *** 80% of network … Continue reading →

1What information does frame tagging add to each frame to allow delivery of frames across a switched trunk? the destination MAC address the switch MAC address *** the VLAN ID the BID    2 Switch1 is not participating in the VTP management process with the other … Continue reading →